Huawei Concheck Param Rev1 76x6t

Group CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel CelSel PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH

PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH PRACH Pwr Ctrl

TDN Rules The minimum required quality threshold corresponding to ICH Ec/No The minimum required quality threshold corresponding to ICH RS The maximum allowed uplink transmit power of a UE in the cell, Threshold for intra-frequency cell measurements in idle mode in SIB3 Threshold for inter-frequency cell measurements in idle mode in SIB3 Threshold for inter-RAT cell measurements in SIB3 and SIB4 Threshold for intra-frequency cell measurements in connected mode in SIB4 Threshold for inter-frequency cell measurements in connected mode in SIB4 Measurement quantity of cell selection and reselection Cell reselection delay time Hysteresis value of the serving cell in idle mode when "QualMeas" is set to ICH_RS(ICH RS) Hysteresis value of the serving cell in connected mode when "QualMeas" is set to ICH_RS(ICH RS) Hysteresis value of the serving cell in idle mode when "QualMeas" is set to ICH_ECNO(ICH Ec/N0) Hysteresis value of the serving cell in connected mode when "QualMeas" is set to ICH_ECNO(ICH Ec/N0) Offset of the measured ICH RS used for cell reselection when the UE is in idle mode Offset of the measured ICH Ec/No used for cell reselection when the UE is in idle mode Cell offset used for ICH RS measurement value in cell selection or reselection when the UE is in connected mode Cell offset used for ICH Ec/No measurement value in cell selection or reselection when the UE is in connected mode Uniquely identifying a PRACH in a cell  the mapping of AC 0~9 to ASCs the mapping of AC 10 to ASCs mapping of AC 11 to ASCs mapping of AC 12 to ASCs mapping of AC 13 to ASCs mapping of AC 14 to ASCs mapping of AC 15 to ASCs Threshold for UE sending RRC CONNECTION REQUEST Maximum number of retransmissions of the RRC CONNECTION REQUEST messag Threshold for UE to start established a dedicated mode Maximum number of consecutive "in sync" indications received from Layer 1 Threshold for UE sends a CELL UPDATE/URA UPDATE Maximum number of retransmissions of the CELL UPDATE/URA UPDATE message Threshold for UE sends a UE CAPABILITY INFORMATION message Maximum number of retransmissions of the UE CAPABILITY INFORMATION message Threshold forUE enters the CELL_FACH, URA_PCH, or CELL_PCH state Threshold for UE sends a UE detects "in service area." Threshold for UE sends a UE sends an RRC CONNECTION RELEASE COMPLETE message Maximum number of retransmissions of the RRC CONNECTION RELEASE COMPLETE message Threshold for UE sends a UE receives a CELL CHANGE ORDER FROM UTRAN message

Threshold for UE sends a UE detects N312 consecutive "in sync" indications from Layer 1 Maximum number of consecutive "in sync" indications received from Layer 1 Threshold for UE sends a UE detects N315 successive "in sync" indications form Layer 1 Maximum number of successive "out of sync" indications received from Layer 1 Threshold for UE sends a radio link synchronization failure are fulfilled and only RBs associated with T314 exist Threshold for UE sends a radio link synchronization failure are fulfilled and only RBs associated with T315 exist Maximum number of successive "in sync" indications received from Layer 1 after T313 starts. Threshold for UE sends a RNC send message "RRC CONNECTION SETUP"(or "CELL UPDATE CONFIRM") Threshold for UE is in the URA_PCH or CELL_PCH state and detects "out of service area. Maximum number of resend times of message "RRC CONNECTION SETUP" or "CELL UPDATE CONFIRM". Threshold for If the UE checks that no PS/CS data is transmitted Max Transmit Power of Cell

Description Min quality level Min Rx level Max allowed UE UL TX power Intra-freq cell reselection threshold for idle mode Inter-freq cell reselection threshold for idle mode Inter-RAT cell reselection threshold Intra-freq cell reselection threshold for connect mode Inter-freq cell reselection threshold for connect mode Cell Sel-reselection quality measure Reselection delay time Hysteresis 1 for idle mode Hysteresis 1 for connect mode Hysteresis 2 for idle mode Hysteresis 2 for connect mode IdleQoffset1sn IdleQoffset2sn ConnQoffset1sn ConnQoffset2sn PRACH ID AC 0~9 to ASC mapping AC 10 to ASC mapping AC 11 to ASC mapping AC 12 to ASC mapping AC 13 to ASC mapping AC 14 to ASC mapping AC 15 to ASC mapping Timer 300 Constant 300 Timer 312 Constant 312 Timer 302 Constant 302 Timer 304 Constant 304 Timer 305 Timer 307 Timer 308 Constant 308 Timer 309

Timer 312 Constant 312 Timer 313 Constant 313 Timer 314 Timer 315 Constant 315 Timer 381 Timer 316 Constant 381 Timer 323 Max Transmit Power of Cell

Parameter Name Qqualmin Qrelevmin MaxAllowedUlTxPower IdleSintrasearch IdleSintersearch SsearchRat ConnSintrasearch ConnSintersearch QualMeas Treselections

Default Value Recommended Value -18 -18 -58 -58 24 24 5 5 4 4 2 2 5 5 4 4 ICH_ECNO(ICH Ec/N0) ICH_ECNO(ICH Ec/N0) 1 1

IdleQhyst1s

2

2

ConnQhyst1s

2

2

IdleQhyst2s

1

1

ConnQhyst2s

1

1

IdleQoffset1sn

0

0

IdleQoffset2sn

0

0

ConnQoffset1sn

0

0

ConnQoffset2sn

0

0

PhyChId Ac09ToAsc Ac10ToAsc Ac11ToAsc Ac12ToAsc Ac13ToAsc Ac14ToAsc Ac15ToAsc T300 N300 T312 N312 T302 N302 T304 N304 T305 T307 T308

4 ASC0 ASC0 ASC0 ASC0 ASC0 ASC0 ASC0 D2000 3 6 D1 D2000 3 D2000 3 D30 D30 D40

4 ASC0 ASC0 ASC0 ASC0 ASC0 ASC0 ASC0 D2000 3 6 D1 D2000 3 D2000 3 D30 D30 D40

N308

1

1

T309

5

5

MaxTxPower

T312

6

6

N312 T313 N313

D1 3 D50

D1 3 D50

T314

D0

D0

T315

D0

D0

N315

D1

D1

T381

D600

D600

T316

D30

D30

N381

D1

D1

T323

INVALID

INVALID 430

448

Remarks Subjected Subjected Subjected Subjected Subjected Subjected Subjected Subjected Subjected Subjected

to to to to to to to to to to

Operators Operators Operators Operators Operators Operators Operators Operators Operators Operators

Requirement Requirement Requirement Requirement Requirement Requirement Requirement Requirement Requirement Requirement

Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement Subjected to Operators Requirement